Laboratory textiles and clothing, rubber, plastic, leather, toys, paper testing and sample preparation field, can be prepared for physical properties, chemical projects and other testing required samples.
1, Two kinds of working mode, suitable for different sample preparation needs;
2, Oil and gas combined with two cylinder pressure, quiet operation, no noise;
3, Multiple safety protection: hands button switch; infrared sensor; cutter installation tips; template installation state; screen soft switch;
4, Can separate the external air compressor, also can be connected with the centralized gas supply device;
5, Pressure speed and time can be adjusted, to adapt to the different needs of sample;
6, With the DM series of die cutter, can be samples of different sizes and size preparation;
7, Special cleaning gun, to prevent cross contamination of samples;
8, Set the initial angle and rotation angle.
The diameter of the press disc
|
20*20cm
|
Air pressure
|
4kg/cm2
|
Sample size
|
according to the requirements of different testing, the samples of different sizes and sizes can be produced with the tool die. The minimum sample size is 5mm x 5mm.
|
The efficiency of sample preparation
|
a complete sample preparation process: 20 seconds or so; sample weight: depending on the material of the sample and the knife mold. In the preparation of 5mm * 5mm textile samples, can produce about 20g, while satisfying the pH value, formaldehyde, azo, composition, pesticide residues and other quantitative test project needs.
|
The maximum working pressure is 10 tons, and the pressure of the working gas is not less than 0.5MPa
|
The shape size
|
500 x 400 x 1200mm
|
Weight
|
200kg
|
The rotation angle can be adjusted
|
30° --180 °
|
You are here: Home>Products>Dyeing and finishing garments
Service Hotline：400-611-2889
